Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2005RENO EXREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALCOMPONENT LOCATIONSDIAGNOSTIC CONNECTOR (DLC) LOCATIONSIMPORTED CARS & TRUCKSTOYOTA
2005 Suzuki Reno EX
Imported Cars & Trucks: TOYOTA
2005 Suzuki Reno EXSECTION TOYOTA
NOTE:
This table provides a quick reference for self-diagnostic connector locations, when available from manufacturer, that ARE NOT
located at the lower left side of the dash, as mandated in 1996 by the Federal government.
TOYOTA - IMPORTED CARS & TRUCKS
| Application | Connector Location | ||
|---|---|---|---|
| Camry | |||
| 1983-90 | Next To Brake Master Cylinder | ||
| 1991 | Near Left Front Shock Tower | ||
| 1992-95 | |||
| 4-Cylinder | Near Wiper Motor | ||
| V6 | Under Left Side Of Dash | ||
| Celica | |||
| 1983-84 | Next To Battery | ||
| 1985-95 | Behind Left Front Shock Tower | ||
| Celica Supra | Rear Of Battery, Near Relay Panel (2-Pin Connector) | ||
| Corolla | |||
| Front Wheel Drive | |||
| 1987 | Side Of Left Front Shock Tower (2-Pin Connector) | ||
| 1988-94 | Behind Left Front Shock Tower | ||
| Rear Wheel Drive | |||
| 1985-86 | Side Of Right Front Shock Tower (2-Pin Connector) | ||
| 1987 | Right Rear Corner Of Engine Compartment | ||
| Cressida | |||
| 1988-93 | |||
| Check Connector | On Left Front Shock Tower | ||
| Total Diagnostic Communication Link Connector | Under Left Side Of Dash | ||
| Land Cruiser (1988-94) | Near Wiper Motor | ||
| MR2 | |||
| 1986-90 | Near Airflow Meter | ||
| 1992-95 | On Right Rear Of Engine Compartment, Near MAP Sensor | ||
| Paseo (1992-95) | On Side Of Engine Compartment Fuse/Relay Block No. 2, Near Battery | ||
| Pickup | |||
| 1984-86 | Near Ignition Coil, Near Master Cylinder (2-Pin Connector) | ||
| 1987-90 | Right Front Inner Fender Panel, Near Relay Block | ||
| 1992-94 | On Side Of Engine Compartment Fuse/Relay Block No. 2, Near Battery | ||
| Previa | |||
| 1992-93 | Under Front Of Driver's Seat | ||
| 1994 | |||
| Except Supercharged | Under Center Console, Near Parking Brake Lever | ||
| Supercharged | Under Cover, On Top Center Of Instrument Panel | ||
| 1995-97 | On Top Center Of Instrument Panel | ||
| RAV4 | Under Dash, Near Center Console | ||
| Starlet | |||
| 1981-82 | On Instrument Panel Fuse Block, On Top Of Dash | ||
| 1983-84 | Right Rear Of Engine Compartment | ||
| Supra | |||
| 1986-90 | Rear Of Battery, Near Relay Panel | ||
| 1991-92 | On Left Front Shock Tower | ||
| 1993-94 | |||
| DLC No. 1 | On Right Side Of Firewall | ||
| DLC No. 2 | Under Left Side Of Dash, Near Kick Panel | ||
| Tacoma & T100 | |||
| 1993 | On Side Of Engine Compartment Fuse/Relay Block No. 2, Near Battery | ||
| 1994-95 | |||
| Except OBD-II DLC | On Side Of Engine Compartment Fuse/Relay Block No. 2, Near Battery | ||
| OBD-II DLC | Under Left Side Of Dash | ||
| Tercel | |||
| 1987-90 | In Engine Compartment, Next To Master Cylinder | ||
| 1991-94 | On Side Of Engine Compartment Fuse/Relay Block No. 2, Near Battery | ||
| 1995-98 | Near Steering Column | ||
| Van | Near Airflow Meter | ||
| 4Runner | |||
| 1985-86 | Near Ignition Coil, Next To Master Cylinder (2-Pin Connector) | ||
| 1987-95 | On Side Of Engine Compartment Fuse/Relay Block No. 2, Near Battery | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.