2005 Suzuki Aerio L4-2.3LFACTORY OEM SERVICE PROCEDURE

Spark Plug: Service and Repair

Spark Plug Removal and Installation

Factory service manual diagram



Removal
1. Disconnect ignition coil coupler.
2. Remove ignition coil bolt (1), and then pull out ignition coil (2).
3. Remove spark plug (3).

Factory service manual diagram



Installation
1. Install spark plug (3) and tighten them to specified torque.

Tightening Torque
Spark plug (a): 25 N.m (2.5 kg-m, 18.0 lb-ft)

2. Install ignition coil (2) securely.
3. Tighten ignition coil bolt (1), and then connect ignition coil coupler.

Tightening Torque
Ignition coil bolt (b): 3 N.m (0.3 kg-m, 2.5 lb-ft)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.