Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Suzuki Aerio L4-2.3LFACTORY OEM SERVICE PROCEDURE
Oxygen Sensor: Service and Repair
Heated Oxygen Sensor (Sensor-1 and Sensor-2) Removal and Installation
Removal
WARNING: To avoid danger of being burned, do not touch exhaust system when system is hot. Oxygen sensor removal should be performed when system is cool.
1. Disconnect negative cable from battery.
2. Disconnect connector of heated oxygen sensor and release its wire harness from clamps.
3. For sensor-2, hoist vehicle.
4. For sensor-1, remove exhaust manifold cover.
5. Remove heated oxygen sensor (1) from exhaust manifold or exhaust No.1 pipe.
Installation
Reference: Heated Oxygen Sensor (Sensor-1 and Sensor-2) Inspection
Reverse removal procedure noting the following.
- Tighten heated oxygen sensor to specified torque.
Tightening torque
Heated oxygen sensor-1 and sensor-2 a: 45 N.m (4.5 kg-m, 32.5 lb-ft)
- Connect connector of heated oxygen sensor and clamp wire harness securely.

- After installing heated oxygen sensor, start engine and check that no exhaust gas leakage exists.
Removal
WARNING: To avoid danger of being burned, do not touch exhaust system when system is hot. Oxygen sensor removal should be performed when system is cool.
1. Disconnect negative cable from battery.
2. Disconnect connector of heated oxygen sensor and release its wire harness from clamps.
3. For sensor-2, hoist vehicle.
4. For sensor-1, remove exhaust manifold cover.
5. Remove heated oxygen sensor (1) from exhaust manifold or exhaust No.1 pipe.
Installation
Reference: Heated Oxygen Sensor (Sensor-1 and Sensor-2) Inspection
Reverse removal procedure noting the following.
- Tighten heated oxygen sensor to specified torque.
Tightening torque
Heated oxygen sensor-1 and sensor-2 a: 45 N.m (4.5 kg-m, 32.5 lb-ft)
- Connect connector of heated oxygen sensor and clamp wire harness securely.
- After installing heated oxygen sensor, start engine and check that no exhaust gas leakage exists.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
