Main Relay (Computer/Fuel System): Testing and Inspection

2001 Suzuki Vitara JLS (2Dr) 2WD L4-2.0LSECTION Testing and Inspection
INSPECTION
1. Disconnect negative cable (-) at battery.




2. Remove main relay (1) from connector.




Main Relay Resistance:




3. Check resistance between each 2 terminals as in table.
If check results are as specified, proceed to next step. If not, replace.




4. Check that there is continuity between terminals "A" and "B" when battery is connected to terminals "C" and "D".
If malfunction is found, replace.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.