Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2001GRAND VITARA LTD 2WD V6-2.5LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSRELAYS AND MODULES - COMPUTERS AND CONTROL SYSTEMSMAIN RELAY (COMPUTER/FUEL SYSTEM)TESTING AND INSPECTION
2001 Suzuki Grand Vitara LTD 2WD V6-2.5L
Main Relay (Computer/Fuel System): Testing and Inspection
2001 Suzuki Grand Vitara LTD 2WD V6-2.5LSECTION Testing and Inspection
INSPECTION
1. Disconnect negative (-) cable at battery.
2. Remove main relay (1) from its connector.
3. Check resistance between each two terminals as in table.
If check results are as specified, proceed to next operation check. If not, replace.
4. Check that there is continuity between terminals "A" and "B" when battery is connected to terminals "C" and "D".
If malfunction is found, replace.
1. Disconnect negative (-) cable at battery.
2. Remove main relay (1) from its connector.
3. Check resistance between each two terminals as in table.
If check results are as specified, proceed to next operation check. If not, replace.
4. Check that there is continuity between terminals "A" and "B" when battery is connected to terminals "C" and "D".
If malfunction is found, replace.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.