Procedures

2001 Suzuki Grand Vitara LTD 2WD V6-2.5LSECTION Procedures



REPLACEMENT BATTERY OF TRANSMITTER
If the transmitter becomes unreliable, replace the battery.
As the battery power is consumed, the operation distance will be shorter.
1. Put the edge of a coin or a flat blade screw driver in the slot (1) of the transmitter and pry it open.
2. Replace the battery (lithium disc-type CR2032 or equivalent) (2) so its "+" terminal faces the "+" mark of the transmitter.

CAUTION: Use care not to allow grease or dirt to be attached on the printed circuit board and the battery.

3. Close the transmitter firmly.
4. Make sure the door locks can be operated with the transmitter.

NOTE:
- To prevent theft, be sure to break the transmitter before discarding it.
- Dispose of the used battery properly according to applicable rules or regulations. Do not dispose of lithium batteries with ordinary household trash.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.