Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Anti-Lock Brake System: Description
Swift is equipped with ABS VI anti-lock brake system. ABS-VI system uses electric motors to modulate pressure control pistons. Anti-Lock Brake System (ABS) operates on each front wheel and both rear wheels. ABS-VI system consists of Electronic Brake Control Module (EBCM), system enable relay, 4 wheel speed sensors, actuator unit, 3 warning lights and brake switch.
EBCM uses signals from wheel speed sensor to determine when a wheel is about to lock and adjusts hydraulic pressure to maintain optimum braking. ABS-VI cannot increase brake pressure greater than master cylinder pressure generated by driver. ABS-VI cannot apply brakes by itself.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.