1995 Suzuki Swift AutomaticFACTORY OEM SERVICE PROCEDURE

EBCM Connector Terminal Identification

EBCM CONNECTOR TERMINAL IDENTIFICATION

Terminal Wire Color (1) Circuit No.
Connector C1
C1 BRN Right Front Motor High
C3 GRN/WHT Stoplight Switch Input
C5 VIO Serial Data Line
C7 GRN/BLK Left Front Motor Low
C9 GRN Left Front Motor High
C10 BLU Left Front Wheel Signal Input
C11 GRN Right Front Wheel Signal Input
C12 GRN/BLK Right Front Wheel Signal Input
C13 YEL Right Rear Wheel Signal Input
C14 YEL/BLK Right Rear Wheel Signal Input
C16 PNK/BLK Rear Motor Low
D1 BRN/BLK Right Front Motor Low
D4 BLU/YEL ABS ACTIVE Indicator Control
D5 BLU ABS Indicator Control
D6 BLK/BLU ABS Enable Relay Control
D7 RED/BLK BRAKE Indicator Control
D8 WHT/GRN Battery Power
D9 YEL/GRN Switched Ignition
D10 BLU/BLK Left Front Wheel Signal Input
D11 ORN Left Rear Wheel Signal Input
D12 ORN/BLK Left Rear Wheel Signal Input
D13 RED/WHT Right Front ABS Solenoid
D14 BLU/WHT Left Front ABS Solenoid
D16 PNK Rear Motor High
Connector C2
1 WHT Switched Battery Power
2 BLK Ground
(1) Terminals not listed are not used.
Fig 1: Identifying EBCM 32-Pin Connector Terminals
G96G20459Courtesy of GENERAL MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.