Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI1990SWIFT GL, 2D HATCHBACK, STANDARDREPAIR AND DIAGNOSISELECTRICALSTARTERSTARTER - DIRECT DRIVEBENCH TESTINGSOLENOID PULL-IN TEST
1990 Suzuki Swift GL, 2D Hatchback, Standard
Solenoid Pull-In Test
1990 Suzuki Swift GL, 2D Hatchback, StandardSECTION Solenoid Pull-In Test
Connect test leads to starter. See Fig 1. Connect negative leads to starter housing and "M" terminal. Battery positive lead is connected to terminal "S". If starter pinion gear does not move out, replace solenoid.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.