Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI1990SWIFT GL, 2D HATCHBACK, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)TRANSMISSIONAUTOMATIC TRANSDIAGNOSIS & OVERHAUL - EEC/MX1ON-VEHICLE SERVICEOIL STRAINERREMOVAL & INSTALLATION
1990 Suzuki Swift GL, 2D Hatchback, Standard
Removal & Installation
1990 Suzuki Swift GL, 2D Hatchback, StandardSECTION Removal & Installation
- Drain transmission fluid. Remove oil pan and oil strainer. See OIL PAN. Clean oil strainer. See Fig 1 .
- Install oil strainer to lower valve body. Tighten oil strainer bolts to 44-53 INCH lbs. (5-6 N.m). Reinstall oil pan. Refill transmission fluid. Warm up transmission. Check for fluid level and leakage.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.