Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI1990SWIFT GL, 2D HATCHBACK, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)TRANSMISSIONAUTOMATIC TRANSDIAGNOSIS & OVERHAUL - EEC/MX1COMPONENT TESTSELECTRIC SHIFT CONTROL SYSTEM COMPONENTSTHROTTLE POSITION SENSOR CHECK
1990 Suzuki Swift GL, 2D Hatchback, Standard
Throttle Position Sensor Check
1990 Suzuki Swift GL, 2D Hatchback, StandardSECTION Throttle Position Sensor Check
Disconnect coupler(s) from A/T control module. For solenoid "D" check, place voltmeter probes on coupler terminals from harness side. See Fig 5 .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.