Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal (Swift DOHC)
1990 Suzuki Swift GA, 4D SedanSECTION Removal (Swift DOHC)
- Relieve fuel system pressure. See FUEL SYSTEM PRESSURE RELEASE under FUEL SYSTEM in this article. Disconnect negative battery cable. Remove idle speed control solenoid valve.
- Remove EGR modulator bracket from intake manifold (if equipped). Disconnect fuel delivery and return hoses from fuel rail. Disconnect vacuum hose from fuel pressure regulator.
- Unplug injector electrical connector from each injector. Remove mounting bolts and lift off fuel rail with injectors. Remove injectors from fuel rail.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.