SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2022IMPREZA BASE, 4D SEDAN, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISTRANSMISSIONTRANSMISSION CONTROL SYSTEMSMT GEAR SHIFT LEVERREMOVAL5MT MODEL
2022 Subaru Impreza Base, 4D Sedan, Automatic CVT Trans

5MT Model

2022 Subaru Impreza Base, 4D Sedan, Automatic CVT TransSECTION 5MT Model
  1. Disconnect the ground terminal from battery sensor. Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
  2. Remove the gear shift knob by turning it counterclockwise.
  3. Remove the front console panel. Ref. to EXTERIOR/INTERIOR TRIM>CONSOLE BOX>REMOVAL .
  4. Remove the panel center LWR LH and RH. Ref. to EXTERIOR/INTERIOR TRIM>CENTER CONSOLE>REMOVAL .
  5. Remove the clamp.
    G08550626Courtesy of SUBARU OF AMERICA, INC.
  6. Remove the boot and insulator assembly.
    G08550627Courtesy of SUBARU OF AMERICA, INC.
  7. Remove the harness clamp from the plate COMPL.
    G08550628Courtesy of SUBARU OF AMERICA, INC.
  8. Remove the plate COMPL from the vehicle body.
    G08550629Courtesy of SUBARU OF AMERICA, INC.
  9. Lift up the vehicle.
  10. Remove the center exhaust cover. Ref. to EXHAUST(H4DO(EXCEPT FOR HEV))>REAR EXHAUST PIPE>REMOVAL .
    NOTE:

    Remove the center exhaust cover only. 

    G13230505Courtesy of SUBARU OF AMERICA, INC.
  11. Remove the stay from the shift bracket.
    G13935620Courtesy of SUBARU OF AMERICA, INC.
  12. Remove the rod from joint.
    G13935621Courtesy of SUBARU OF AMERICA, INC.
  13. Remove the cushion rubber from the vehicle body.
    G13935622Courtesy of SUBARU OF AMERICA, INC.
  14. Extract the spring pin and remove the joint.
    G13935623Courtesy of SUBARU OF AMERICA, INC.
  15. Remove the gear shift lever from the bottom of the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.