Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2022IMPREZA BASE, 4D SEDAN, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISTRANSMISSIONTRANSMISSION CONTROL SYSTEMSGENERAL DIAGNOSTIC TABLEINSPECTION
2022 Subaru Impreza Base, 4D Sedan, Automatic CVT Trans
General Diagnostic Table: Inspection
2022 Subaru Impreza Base, 4D Sedan, Automatic CVT TransSECTION Inspection
| Symptoms | Possible cause | Corrective action |
|---|---|---|
| AT select lever | Starter does not run. | Adjust the select cable and inhibitor switch, or inspect the circuit. |
| Back-up light does not illuminate. | Adjust the select cable and inhibitor switch, or inspect the circuit. | |
| AT shift lock system does not operate normally. | Adjust the select cable and inhibitor switch, or inspect the circuit. | |
| Manual mode cannot be set. | Inspect the mode switch and select lever, or inspect the circuit. | |
| Up-shift is not engaged at manual mode. | Check the shift-up switch and circuit. | |
| Down-shift is not engaged at manual mode. | Check the shift-down switch and circuit. | |
| MT gear shift lever (6MT) | Cannot shift into reverse. | Adjust the MT gear select cable. |
| Shifted to 6th though it shifted to reverse. | Adjust or replace the MT gear select cable. | |
| Can shift into reverse when the slider is not pulled up. | Adjust or replace the MT gear select cable. | |
| Slider cannot be pulled up or sticks in the pulled-up position. |
|
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.