Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2022IMPREZA BASE, 4D SEDAN, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSCVT TRANSAXLE (TR580)AWD ON/OFF SWITCHING MODEPROCEDURE
2022 Subaru Impreza Base, 4D Sedan, Automatic CVT Trans
AWD ON/OFF Switching Mode: Procedure
2022 Subaru Impreza Base, 4D Sedan, Automatic CVT TransSECTION Procedure
CAUTION:
- Do not turn the power of the Subaru Select Monitor OFF during work, and do not disconnect the data link connector .
- On completing the work in FWD, switch back in AWD .
- Shift the select lever to the "P" range.
- Connect the Subaru Select Monitor.
- Turn the ignition switch to ON.
- Turn off all switches causing an electrical load, such as headlights, A/C, seat heater and rear defogger.
- Select [Diagnosis] on [Start] display of Subaru Select Monitor.
- On [Vehicle selection] screen, enter vehicle information and select [OK].
- On [Main Menu] screen, select [Each System].
- On [Select System] screen, select [Transmission].
- On [Select Function] screen, select [Work Support].
- On [Work Support] screen, select [AWD ON/OFF switching mode].
- Follow the messages displayed on the Subaru Select Monitor screen when working. Switching completes successfully if any of the following messages is displayed.
- When switching from AWD to FWD: [Switched to FF. To return to AWD, perform basic mode again.]
- When switching from FWD to AWD: [Switched to AWD. To return to FF, perform basic mode again.]
NOTE:
- If communication error occurs during switching mode, start in the [AWD ON/OFF switching mode] again .
- If operation is interrupted before the successful end message is displayed, perform the [AWD ON/OFF switching mode] from the beginning until confirming the operation is successfully ended. If this mode fails to complete successfully, the cause is as follows .
- Select lever is not in "P" range .
- Engine is running .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.