Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2022IMPREZA BASE, 4D SEDAN, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSAUTOMATIC TRANSAXLE (DIAGNOSTICS)INSPECTION MODEPROCEDUREINSPECTION MODE B
2022 Subaru Impreza Base, 4D Sedan, Automatic CVT Trans
Inspection Mode B
2022 Subaru Impreza Base, 4D Sedan, Automatic CVT TransSECTION Inspection Mode B
| DTC | Description & trouble part | Condition |
|---|---|---|
| P0711 | TRANSMISSION FLUID TEMPERATURE SENSOR "A" CIRCUIT RANGE/PERFORMANCE | - |
Diagnostic procedure:
- Start the engine under condition that ATF temperature is at 20°C (68°F) or below.
- Check the readiness code of [Transmission] using Subaru Select Monitor and confirm that the diagnosis is not completed. Ref. to TRANSMISSION (DIAGNOSTICS) (IMPREZA MODEL)>ALL READINESS DIAGNOSTIC CODE(S) .
- Drive in any driving pattern for 20 minutes. (Include driving at a constant legal speed (for 20 seconds) at least once.)NOTE:
Repeat two or more driving cycles in this driving pattern.
- Check the readiness code of [Transmission] using Subaru Select Monitor and confirm that the diagnosis is completed. Ref. to TRANSMISSION (DIAGNOSTICS) (IMPREZA MODEL)>ALL READINESS DIAGNOSTIC CODE(S) .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.