Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2022IMPREZA BASE, 4D SEDAN, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSAUTOMATIC TRANSAXLE (DIAGNOSTICS)DIAGNOSTIC PROCEDURE WITH DIAGNOSTIC TROUBLE CODE (DTC)DTC P2757: TORQUE CONVERTER CLUTCH PRESSURE CONTROL SOLENOID CONTROL CIRCUIT PERFORMANCE/STUCK OFFGENERAL DESCRIPTIONEXECUTION CONDITION
2022 Subaru Impreza Base, 4D Sedan, Automatic CVT Trans
Execution Condition
2022 Subaru Impreza Base, 4D Sedan, Automatic CVT TransSECTION Execution Condition
| Secondary parameters | Execution condition |
|---|---|
| 12 V battery system voltage | 10 V or more |
| Engine speed | 1000 rpm or more |
| Transmission range | Drive |
| Commanded duty of torque converter clutch pressure control solenoid | 95% or more |
| Measured turbine shaft speed | Exceeds rpm values in Table below |
ENGINE SPEED SPECIFICATIONS
| Engine speed (rpm) | 3700 | 3727 | 3755 | 3782 | 3856 | 4019 | 4213 | 4456 |
| Measured turbine shaft speed (rpm) | 0 | 500 | 1000 | 1500 | 2000 | 2500 | 3000 | 3500 |
| Engine speed (rpm) | 4786 | 5213 | 5651 | 6101 | 6569 | 7044 | 7520 | |
| Measured turbine shaft speed (rpm) | 4000 | 4500 | 5000 | 5500 | 6000 | 6500 | 7000 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.