SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2022IMPREZA BASE, 4D SEDAN, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISSTEERINGELECTRONIC STEERINGPOWER STEERING SYSTEMGENERAL DIAGNOSTIC TABLEINSPECTIONNOTES
2022 Subaru Impreza Base, 4D Sedan, Automatic CVT Trans

General Diagnostic Table: Inspection: Notes

2022 Subaru Impreza Base, 4D Sedan, Automatic CVT TransSECTION Notes
Trouble Possible cause Corrective action
  • Steering effort is heavy in all ranges.
  • Steering effort is heavy at stand still.
  • Steering wheel vibrates when turning.
 1. Tire and wheel
  • Improper tire out of specifications
  • Improper wheel out of specification
  • Tires not properly inflated
 Replace the tire and wheel, or reinflate the tire.
2. Measure the steering wheel effort. Ref. to POWER ASSISTED SYSTEM (POWER STEERING)>GENERAL DIAGNOSTIC TABLE>INSPECTION>MEASUREMENT OF STEERING EFFORT . Adjust or replace the faulty parts.
  • Vehicle leads to one side or the other.
  • Returning force of steering wheel to center is poor.
  • Steering wheel vibrates when turning.
 1. Tire and wheel
  • Flat tire
  • Mixed use of different tires
  • Mixed use of different wheels
  • Abnormal wear of tire
  • Unequal tread remaining
  • Unequal pressure of tire
 Adjust, repair or replace the tire and wheel.
2. Front wheel alignment
  • Improper or unequal caster
  • Improper or unequal toe-in
  • Loose suspension connections
 Adjust or retighten.
3. Measure the steering wheel effort. Ref. to POWER ASSISTED SYSTEM (POWER STEERING)>GENERAL DIAGNOSTIC TABLE>INSPECTION>MEASUREMENT OF STEERING EFFORT . Adjust or replace the faulty parts.
NOTE:

When performing repeated steering operation with the vehicle at standstill, the steering effort may be temporarily heavy because the heat generated in the system activates the power steering protection control. This is not a malfunction caused by the steering system. After a while, it will return to normal steering effort. (In this case, the steering warning light will not come on and there will be no DTC.) 

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.