Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSSUBARU2022IMPREZA BASE, 4D SEDAN, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISRESTRAINTSAIR BAG, SRSAIRBAG SYSTEMKNEE AIRBAG MODULEINSTALLATION

2022 Subaru Impreza Base, 4D Sedan, Automatic CVT Trans

Knee Airbag Module: Installation

2022 Subaru Impreza Base, 4D Sedan, Automatic CVT TransSECTION Installation

CAUTION:

Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION .
Do not allow harness and connectors to interfere or get tangled up with other parts.

Before installation, inspect the following items and replace any faulty part with a new one.
- Knee airbag module is cracked or deformed.
- Claw portion of the metallic case of knee airbag module is not aligned with the plastic cover.
- Knee airbag module bracket is cracked or deformed.
- Harness and/or connector is cracked, deformed or open.
- Harness wire is exposed.
- Depending on the condition of the beam COMPL - steering, installation of the knee airbag module is difficult.
Install the knee airbag module.
CAUTION:
- Be sure to insert the connector in completely until it is locked.
- Press in the push lock of the direct type connector securely. Then pull it gently to make sure that it is locked.
Tightening torque:

7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
Install the data link connector.
Install the cover assembly - instrument panel LWR driver. Ref. to EXTERIOR/INTERIOR TRIM>INSTRUMENT PANEL LOWER COVER>INSTALLATION .
Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
NOTE:
For the hybrid model, connect the battery negative terminal.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.