SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2022IMPREZA BASE, 4D SEDAN, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISGENERAL INFORMATIONTOWINGGENERAL INFORMATION & SPECIFICATIONSPRE-DELIVERY INSPECTIONPRE-DELIVERY INSPECTION (PDI) PROCEDURETPMS (U.S. MODEL)CROSSTREK MODEL
2022 Subaru Impreza Base, 4D Sedan, Automatic CVT Trans

CROSSTREK Model

2022 Subaru Impreza Base, 4D Sedan, Automatic CVT TransSECTION CROSSTREK Model
  1. Turn the TPMS transmitter power supply to ON.
    1. Turn the ignition switch to ON, and check that the TPMS warning light is blinking as follows.
      G12391277Courtesy of SUBARU OF AMERICA, INC.
    2. Make the transmitter registration tool come in contact with the side wall area near the air valve on each tire, and press the switch to irradiate a magnetic field of 125 kHz for 4 seconds or more.
      G13875226Courtesy of SUBARU OF AMERICA, INC.
    3. Make sure that the TPMS warning light goes off when the power for 4 wheels is turned to ON.
      NOTE:
      • When the power for only 1 through 3 wheels is turned to ON, the light blinks as follows. 
      • For Subaru Select Monitor, make sure that the transmitter power supply is set to «ON MODE». 
      G12391279Courtesy of SUBARU OF AMERICA, INC.
    4. Turn the ignition switch to ON, and check TPMS warning light for normal operation.
      • Normal operation (IG ON (light check))
      G13590099Courtesy of SUBARU OF AMERICA, INC.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.