Section 2 (M/T Clutch System): Flywheel: Removal

2022 Subaru Impreza Base, 4D Sedan, Automatic CVT TransSECTION Removal
WARNING: This page is about a different variant/trim than selected.
  1. Remove the manual transmission assembly.
  2. Remove the clutch cover and clutch disc. Ref. to CLUTCH SYSTEM>CLUTCH DISC AND COVER>REMOVALΒ .
  3. Attach the ST.

    Preparation tool:Β 

    ST: CRANKSHAFT STOPPER (498497100)

    G13937892Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the flywheel and crankshaft position sensor plate.
  5. Drive out the pilot bearing from the flywheel.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.