SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2022IMPREZA BASE, 4D SEDAN, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 2 (M/T CLUTCH SYSTEM)CLUTCH SWITCHINSPECTIONCLUTCH START SWITCH
2022 Subaru Impreza Base, 4D Sedan, Automatic CVT Trans

Clutch Start Switch

2022 Subaru Impreza Base, 4D Sedan, Automatic CVT TransSECTION Clutch Start Switch
WARNING: This page is about a different variant/trim than selected.
  1. Perform inspections for the clutch start system, and if it does not operate normally, adjust the clutch start switch and check it again. Ref. to CLUTCH SYSTEM>CLUTCH SWITCH>ADJUSTMENTΒ .
  2. When the clutch start switch does not operate normally even if it is adjusted, check the clutch start switch for continuity.
    1. Remove the clutch start switch. Ref. to CLUTCH SYSTEM>CLUTCH SWITCH>REMOVALΒ .
    2. Measure the resistance between terminal 1 and 2 of the switch. If the resistance is not within the standard value, replace the switch.
      Condition Terminal No. Standard
      ON No. 1 - No. 2 Less than 1 Ξ©
      OFF No. 1 - No. 2 1 MΞ© or more
      G10323203Courtesy of SUBARU OF AMERICA, INC.
    3. Check that the switch is turned on and off in dimension L.

      Dimension L:Β 

      9 - 10 mm (0.35 - 0.39 in)

      G13937983Courtesy of SUBARU OF AMERICA, INC.
    4. Install the clutch start switch. Ref. to CLUTCH SYSTEM>CLUTCH SWITCH>INSTALLATION>CLUTCH START SWITCHΒ .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.