Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2022IMPREZA BASE, 4D SEDAN, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 5 (FUEL INJECTION SYSTEM (HEV))GENERAL DESCRIPTIONPREPARATION TOOLGENERAL TOOL
2022 Subaru Impreza Base, 4D Sedan, Automatic CVT Trans
General Tool
2022 Subaru Impreza Base, 4D Sedan, Automatic CVT TransSECTION General Tool
WARNING: This page is about a different car, the 2022 Subaru Crosstrek. However, it is still accessible from the selected car via links, so may be relevant.
| TOOL NAME | REMARKS | |
|---|---|---|
| Insulated gloves | Used for removing/installing and inspecting high voltage components. | |
| Goggles | ||
| Rubber boots for electrical purposes, insulated protective shoes or insulating mat | ||
| Insulating sheet | ||
| Insulated tools | Insulated 10-mm socket | |
| Insulated extension | ||
| Insulated ratchet handle | ||
| Insulated torque wrench | ||
| Insulated flat tip screwdriver | ||
| TORX PLUS® 40IP | Used for removing and installing high-pressure fuel pump. | |
| Circuit tester | Used for measuring resistance, voltage and current. | |
| Oscilloscope | Used for inspecting the manifold absolute pressure sensor. | |
| Mighty Vac | Used for measuring resistance, voltage and current. | |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.