Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2022IMPREZA BASE, 4D SEDAN, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 4 (ENGINE STARTING SYSTEM & CHARGING SYSTEM (HEV))BATTERYINSTALLATION
2022 Subaru Impreza Base, 4D Sedan, Automatic CVT Trans
Section 4 (Engine Starting System & Charging System (HEV)): Battery: Installation
2022 Subaru Impreza Base, 4D Sedan, Automatic CVT TransSECTION Installation
WARNING: This page is about a different car, the 2022 Subaru Crosstrek. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- If the battery terminal is worn and the terminal section is loose, replace it with a new battery.
- Since the initial diagnosis of the electronic throttle control is conducted after the battery terminal is connected, wait for 10 seconds or more after turning the ignition switch to ON, and then start the engine.
- Install the battery.
- Install the battery holder.
Tightening torque:
3.5 N.m (0.4 kgf-m, 2.6 ft-lb)
- Install the battery cable holder.
- Connect the battery positive terminal.
Tightening torque:
6 N.m (0.6 kgf-m, 4.4 ft-lb)
- Connect the battery ground terminal. Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.