SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2022IMPREZA BASE, 4D SEDAN, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 37 (EMISSION CONTROL SYSTEMS (AUX. EMISSION CONTROL DEVICES) (HEV))EGR CONTROL VALVEINSTALLATION
2022 Subaru Impreza Base, 4D Sedan, Automatic CVT Trans

EGR Control Valve: Installation

2022 Subaru Impreza Base, 4D Sedan, Automatic CVT TransSECTION Installation
WARNING: This page is about a different car, the 2022 Subaru Crosstrek. However, it is still accessible from the selected car via links, so may be relevant.
  1. Set a new gasket and O-rings.
    G13231131Courtesy of SUBARU OF AMERICA, INC.
  2. Install the EGR control valve.

    Tightening torque: 

    19 N.m (1.9 kgf-m, 14.0 ft-lb)

    G13231130Courtesy of SUBARU OF AMERICA, INC.
  3. Attach the bracket.

    Tightening torque: 

    19 N.m (1.9 kgf-m, 14.0 ft-lb)

    G13231129Courtesy of SUBARU OF AMERICA, INC.
  4. Connect the preheater hose (B) and preheater hose (C).
  5. Connect the connector (A).
    G13231128Courtesy of SUBARU OF AMERICA, INC.
  6. Install the air intake duct. Ref. to INTAKE (INDUCTION) (H4DO (EXCEPT FOR HEV))>AIR INTAKE DUCT>INSTALLATION .
  7. Connect the battery ground terminal. Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
  8. Fill the engine coolant (engine side). Ref. to COOLING (H4DO(HEV))>ENGINE COOLANT>REPLACEMENT>FILLING OF ENGINE COOLANT>ENGINE SIDE .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.