Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2022IMPREZA BASE, 4D SEDAN, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 30 (ENGINE CONTROL SYSTEM (HEV) (DIAGNOSTICS) (4 OF 4))DIAGNOSTIC PROCEDURE WITH DIAGNOSTIC TROUBLE CODE (DTC)DTC P2610: ECM/PCM ENGINE OFF TIMER PERFORMANCEGENERAL DESCRIPTIONEXECUTION CONDITION
2022 Subaru Impreza Base, 4D Sedan, Automatic CVT Trans
Execution Condition
2022 Subaru Impreza Base, 4D Sedan, Automatic CVT TransSECTION Execution Condition
WARNING: This page is about a different car, the 2022 Subaru Crosstrek. However, it is still accessible from the selected car via links, so may be relevant.
| Secondary parameters | Execution condition |
|---|---|
| Monitor#1 <Timer diagnosis> | |
| Ignition switch | OFF |
| Battery voltage | 10.9 V or more |
| Elapsed time after starting the engine | More than 19 s and Less than 61439 s |
| Monitor#2 <Full count diagnosis> | |
| Ignition switch | OFF |
| Battery voltage | 10.9 V or more |
| Counter in ECM | 4 s or more |
| Monitor#3 <Soaking timer IC setting diagnosis> | |
| Ignition switch | OFF |
| Battery voltage | 10.9 V or more |
| Monitor#4 <Timer diagnosis (during soaking)> | |
| Ignition switch | OFF |
| Battery voltage | 10.9 V or more |
| Monitor#5 <Wake-up diagnosis> | |
| Ignition switch | ON |
| Time in the soaking timer IC | More than 3600s |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.