Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Inspection Without Using Can Diagnostic
Trouble causes:
- Electrical system malfunction
- Faulty harness and harness connector
Before performing diagnosis, refer to "CAUTION" in "General Description". Ref. to LAN SYSTEM (DIAGNOSTICS) (HEV)>GENERAL DESCRIPTION>CAUTION .
- CHECK BATTERY
.
Check the battery. Ref. to STARTING/CHARGING SYSTEMS (H4DO(HEV))>BATTERY>INSPECTION .
Is the check result OK?
Yes: Go to 2.
No: Charge or replace the battery.
- CHECK FUSE
.
Check the fuse which might affect the problem.
Is the check result OK?
Yes: Go to 3.
No: Replace the fuse. If the replaced fuse blows out easily, some type of fault is present. Therefore, repair the faulty portion.
- CHECK HARNESS
.
Check the harness and harness connector connection which might affect the problem.
Is the check result OK?
Yes: Go to step 3 in the Basic Diagnostic Procedure. Ref. to LAN SYSTEM (DIAGNOSTICS) (HEV)>BASIC DIAGNOSTIC PROCEDURE>PROCEDURE .
No: Repair or replace the faulty harness or harness connector.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.