System Block Diagram

2022 Subaru Impreza Base, 4D Sedan, Automatic CVT TransSECTION System Block Diagram
WARNING: This page is about a different car, the 2022 Subaru Crosstrek. However, it is still accessible from the selected car via links, so may be relevant.
  • A/C control and status display

    Using the CAN communication, perform A/C control from vehicle information and each sensor value to actuate the A/C system device. Also display A/C status on MFD by CAN output of A/C status.

  • Hazard is ON

    Output hazard switch signals to body integrated unit. The control of hazard illumination is carried out via body integrated unit.

  • Illumination

    Adjust the A/C control panel lighting according to input (body integrated unit and combination meter).

  • Engine control

    Transmit the A/C status via CAN for engine control.

  • Rear defogger operation

    Output switch signals to body integrated unit. The control of rear defogger operation is carried out via body integrated unit.

  • Mirror heater operation

    Output switch signals to body integrated unit. The control of mirror heater operation is carried out via body integrated unit.

  • Voice recognition

    Change the A/C setting according to voice input in combination with AVN.

  • Remote climate control (RCC)

    Operate and stop RCC in combination with Electric vehicle charger assembly, keyless access control module, DCM, body integrated unit, Hybrid vehicle control ECU assembly, access key, and smartphone (mobile phone).

G13942764Courtesy of SUBARU OF AMERICA, INC.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.