SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2022IMPREZA BASE, 4D SEDAN, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 23 (P-HEV HYBRID POWERTRAIN CONTROL SYSTEM (DIAGNOSTICS) (3 OF 4))DIAGNOSTIC PROCEDURE WITH DIAGNOSTIC TROUBLE CODE (DTC)DTC P1CD8-00: HYBRID/EV POWERTRAIN CONTROL MODULE PROCESSOR OR MONITORING PROCESSOR CHARGING PERMISSION SIGNAL INTERNAL FAILURENOTES
2022 Subaru Impreza Base, 4D Sedan, Automatic CVT Trans

DTC P1CD8-00: Hybrid/EV Powertrain Control Module Processor Or Monitoring Processor Charging Permission Signal Internal Failure: Notes

2022 Subaru Impreza Base, 4D Sedan, Automatic CVT TransSECTION Notes
WARNING: This page is about a different car, the 2022 Subaru Crosstrek. However, it is still accessible from the selected car via links, so may be relevant.
  1. - 

    Outline of diagnosis: 

    The charger gate permission signal from Hybrid vehicle control ECU assembly is faulty

    (1 trip detection logic)

    Trouble symptom: 

    Plug-in charging suspended

    CAUTION:

    Before performing diagnosis, refer to "CAUTION" in "General Description". Ref. to  P-HEV HYBRID POWERTRAIN CONTROL (DIAGNOSTICS)>GENERAL DESCRIPTION>CAUTION  . 

  1. CHECK DTC  .

    Read the following DTCs using Subaru Select Monitor. Ref. to P-HEV HYBRID POWERTRAIN CONTROL (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) . Ref. to PLUG-IN BATTERY CHARGER (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) .

    • P-HEV Hybrid Powertrain Control
    • Plug-in Battery Charger
    NOTE:
    Malfunction contents System Related DTC
    Microcomputer malfunction P-HEV Hybrid Powertrain Control P0606-47 HYBRID/EV POWERTRAIN CONTROL MODULE PROCESSOR WATCHDOG/SAFETY MCU FAILURE
    P0606-87 HYBRID/EV POWERTRAIN CONTROL MODULE PROCESSOR TO MONITORING PROCESSOR MISSING MESSAGE
    P060A-47 HYBRID/EV POWERTRAIN CONTROL MODULE MONITORING PROCESSOR WATCHDOG/SAFETY MCU FAILURE
    P060A-87 HYBRID/EV POWERTRAIN CONTROL MODULE PROCESSOR FROM MONITORING PROCESSOR MISSING MESSAGE
    P1C9E-9F HYBRID/EV SYSTEM RESET STUCK OFF
    P1CD9-00 HYBRID/EV POWERTRAIN CONTROL MODULE PROCESSOR AND MONITORING PROCESSOR CHARGING PERMISSION SIGNAL STUCK ON
    Plug-in Battery Charger P060B-49 PLUG-IN CONTROL MODULE A/D PROCESSING INTERNAL ELECTRONIC FAILURE
    Communication system malfunction Plug-in Battery Charger U019B-87 LOST COMMUNICATION WITH HYBRID/EV BATTERY CHARGER CONTROL MODULE MISSING MESSAGE

    When "Only DTC P1CD8-00 is displayed" or "DTC other than above is displayed", go to  A.

    When DTCs related to [P-HEV Hybrid Powertrain Control], mentioned above, are simultaneously displayed, go to  B.

    When DTCs related to [Plug-in Battery Charger], mentioned above, are simultaneously displayed, go to  C.

    Yes: 

    1. Replace Hybrid vehicle control ECU assembly. Ref. to HYBRID ELECTRIC VEHICLE>HYBRID POWERTRAIN CONTROL MODULE .
    2. Perform the diagnosis for the simultaneously displayed DTCs.
      NOTE:

      If more than one DTC is simultaneously displayed, perform the diagnosis in the order described in the above. 

    3. Perform the diagnosis for the simultaneously displayed DTCs.
      NOTE:

      If more than one DTC is simultaneously displayed, perform the diagnosis in the order described in the above. 

    No: 

    -

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.