Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2022IMPREZA BASE, 4D SEDAN, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 17 (ENGINE CONTROL SYSTEM (2.5L) (DIAGNOSTICS) - INTRODUCTION)INSPECTION MODEPROCEDUREINSPECTION MODE AC
2022 Subaru Impreza Base, 4D Sedan, Automatic CVT Trans
Inspection Mode Ac
2022 Subaru Impreza Base, 4D Sedan, Automatic CVT TransSECTION Inspection Mode Ac
WARNING: This page is about a different car, the 2022 Subaru Crosstrek. However, it is still accessible from the selected car via links, so may be relevant.
| DTC | Description and trouble part | Condition | Number of driving cycles on the detecting condition |
|---|---|---|---|
| P26A5 | ENGINE COOLANT BYPASS VALVE "A" POSITION SENSOR CIRCUIT RANGE/PERFORMANCE | [Engine Coolant Temperature 1]: 0°C (32°F) or more | 2 |
- Check that the battery voltage is 12 V or more and fuel remains approx. half [20 - 40 L (5.3 - 10.6 US gal, 4.4 - 8.8 Imp gal)].
- Using the Subaru Select Monitor, perform the clear memory of [Engine]. Ref. to COMMON (DIAG)>CLEAR MEMORY .
- Start the engine and let it idle.
- Turn the ignition switch to OFF and wait for approx. 3 minutes or more.
- Turn the ignition switch to ON, and read the temporary code using the Subaru Select Monitor or general scan tool. Ref. to COMMON (DIAG)>DIAGNOSTIC TROUBLE CODE (DTC) .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.