Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2022IMPREZA BASE, 4D SEDAN, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 17 (ENGINE CONTROL SYSTEM (2.5L) (DIAGNOSTICS) - INTRODUCTION)INSPECTION MODEPROCEDUREINSPECTION MODE A
2022 Subaru Impreza Base, 4D Sedan, Automatic CVT Trans
Inspection Mode A
2022 Subaru Impreza Base, 4D Sedan, Automatic CVT TransSECTION Inspection Mode A
WARNING: This page is about a different car, the 2022 Subaru Crosstrek. However, it is still accessible from the selected car via links, so may be relevant.
| DTC | Description and trouble part | Condition | Number of driving cycles on the detecting condition |
|---|---|---|---|
| P0087 | FUEL RAIL/SYSTEM PRESSURE - TOO LOW BANK 1 | Complete diagnosis with inspection mode B as well. | 1 |
| P0088 | FUEL RAIL/SYSTEM PRESSURE - TOO HIGH BANK 1 | Complete diagnosis with inspection mode B as well. | 1 |
| P0128 | COOLANT THERMOSTAT (COOLANT TEMPERATURE BELOW THERMOSTAT REGULATING TEMPERATURE) | - | 2 |
| P013A | O2 SENSOR SLOW RESPONSE - RICH TO LEAN BANK 1 SENSOR 2 | - | 2 |
| P013E | O2 SENSOR DELAYED RESPONSE - RICH TO LEAN BANK 1 SENSOR 2 | - | 2 |
| P0141 | O2 SENSOR HEATER CIRCUIT BANK 1 SENSOR 2 | - | 2 |
| P014C | A/F/O2 SENSOR SLOW RESPONSE - RICH TO LEAN BANK 1 SENSOR 1 | - | 2 |
| P014D | A/F/O2 SENSOR SLOW RESPONSE - LEAN TO RICH BANK 1 SENSOR 1 | - | 2 |
| P015A | A/F/O2 SENSOR DELAYED RESPONSE - RICH TO LEAN BANK 1 SENSOR 1 | - | 2 |
| P015B | A/F/O2 SENSOR DELAYED RESPONSE - LEAN TO RICH BANK 1 SENSOR 1 | - | 2 |
| P0171 | SYSTEM TOO LEAN BANK 1 | Complete diagnosis with inspection mode B as well. | 2 |
| P0172 | SYSTEM TOO RICH BANK 1 | Complete diagnosis with inspection mode B as well. | 2 |
| P0300 | RANDOM/MULTIPLE CYLINDER MISFIRE DETECTED | Complete diagnosis with inspection mode B as well. | 2 |
| P0301 | CYLINDER 1 MISFIRE DETECTED | Complete diagnosis with inspection mode B as well. | 2 |
| P0302 | CYLINDER 2 MISFIRE DETECTED | Complete diagnosis with inspection mode B as well. | 2 |
| P0303 | CYLINDER 3 MISFIRE DETECTED | Complete diagnosis with inspection mode B as well. | 2 |
| P0304 | CYLINDER 4 MISFIRE DETECTED | Complete diagnosis with inspection mode B as well. | 2 |
| P0459 | EVAP SYSTEM (CPC) PURGE CONTROL VALVE "A" CIRCUIT HIGH | - | 2 |
| P0562 | SYSTEM VOLTAGE LOW | - | 1 |
| P0563 | SYSTEM VOLTAGE HIGH | - | 1 |
| P2096 | POST CATALYST FUEL TRIM SYSTEM TOO LEAN BANK 1 | Complete diagnosis with inspection mode B as well. | 2 |
| P2097 | POST CATALYST FUEL TRIM SYSTEM TOO RICH BANK 1 | Complete diagnosis with inspection mode B as well. | 2 |
| P2195 | A/F/O2 SENSOR SIGNAL BIASED/STUCK LEAN BANK 1 SENSOR 1 | - | 2 |
| P2196 | A/F/O2 SENSOR SIGNAL BIASED/STUCK RICH BANK 1 SENSOR 1 | - | 2 |
| P2270 | O2 SENSOR SIGNAL BIASED/STUCK LEAN BANK 1 SENSOR 2 | - | 2 |
| P2271 | O2 SENSOR SIGNAL BIASED/STUCK RICH BANK 1 SENSOR 2 | - | 2 |
WARNING:
When performing inspection mode A on a public road, pay sufficient attention to the traffic condition and give the highest priority to safe driving.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.