Inspection Mode Z

2022 Subaru Impreza Base, 4D Sedan, Automatic CVT TransSECTION Inspection Mode Z
DTC Description and trouble part Condition Number of driving cycles on the detecting condition
P0030 A/F/O2 HEATER CONTROL CIRCUIT BANK 1 SENSOR 1 - 2
P0068 MAP/MAF - THROTTLE POSITION CORRELATION - 2
P0101 MASS OR VOLUME AIR FLOW SENSOR "A" CIRCUIT RANGE/PERFORMANCE - 2
P219C Cylinder 1 Air-Fuel Ratio Imbalance - 2
P219D Cylinder 2 Air-Fuel Ratio Imbalance - 2
P219E Cylinder 3 Air-Fuel Ratio Imbalance - 2
P219F Cylinder 4 Air-Fuel Ratio Imbalance - 2
WARNING:

When performing inspection mode Z on a public road, pay sufficient attention to the traffic condition and give the highest priority to safe driving.Β 

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.