Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2022IMPREZA BASE, 4D SEDAN, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISAUTO START STOP (DIAGNOSTICS)ACTIVE TESTLISTNOTES
2022 Subaru Impreza Base, 4D Sedan, Automatic CVT Trans
Active Test: List: Notes
2022 Subaru Impreza Base, 4D Sedan, Automatic CVT TransSECTION Notes
NOTE:
- Before performing the active test for Auto Start Stop, execution conditions listed below must be met in each item.
- *: The restart conditions after stopping the engine are the same as that of "Auto Start Stop restart conditions". Ref. to AUTO START STOP (DIAGNOSTICS)>DATA MONITOR>LIST .
| Active test item | Contents | Execution condition |
|---|---|---|
| Electric oil pump control (Relay ON/OFF drive) | ON/OFF of the electric oil pump relay (Auto Start Stop) can be set. |
|
| Electric oil pump control (Pump ON/OFF drive) | Command duty of the electric oil pump (Auto Start Stop) can be set to 10 → 65% (for 120 seconds). |
|
| Sub power supply control (ON/OFF Dr.) | DC/DC converter can be set to ON (2 seconds). | "Common execution condition" established |
| Engine stop control* | Auto Start Stop can be performed without driving the vehicle. | Auto Start Stop condition is established Ref. to AUTO START STOP (DIAGNOSTICS)>DATA MONITOR . |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.