Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSSUBARU2022IMPREZA BASE, 4D SEDAN, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISENGINE MECHANICALSTARTERENGINE STARTING SYSTEM & CHARGING SYSTEM (EXCEPT FOR HEV)AUTO START STOP OFF SWITCHINSPECTION
2022 Subaru Impreza Base, 4D Sedan, Automatic CVT Trans
Auto Start Stop OFF Switch: Inspection
2022 Subaru Impreza Base, 4D Sedan, Automatic CVT TransSECTION Inspection
- Check that there is no deformation, cracks or other damages.
- Check the resistance between terminals shown in the following table.
Terminal No. Inspection conditions Standard 6 - 8 Switch ON Less than 1 Ξ© Switch OFF 1 MΞ© or more - Apply battery voltage between the terminals shown in the table below to check lighting condition of illumination inside the switch.CAUTION:
When applying battery voltage, do not mix up the positive (+) side and the negative (-) side.Β
Incorrect polarity connection may cause LED damage inside the switch.Β
Terminal No. Inspection conditions Condition 1 (+) - 4 (-) Apply battery voltage. Light ON
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.