Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSSUBARU2022IMPREZA BASE, 4D SEDAN, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISELECTRICALGAUGESINSTRUMENTATION SYSTEM & DRIVER INFORMATION CENTERSWITCHES AND HARNESSINSPECTIONMULTI-FUNCTION DISPLAY SWITCH

2022 Subaru Impreza Base, 4D Sedan, Automatic CVT Trans

Multi-Function Display Switch

2022 Subaru Impreza Base, 4D Sedan, Automatic CVT TransSECTION Multi-Function Display Switch

Measure the resistance between connector terminals.

Preparation tool:

Circuit tester

Model without SI-DRIVE

Courtesy of SUBARU OF AMERICA, INC.

Terminal No.	Inspection conditions		Standard
8 - 7	INFO	OFF	3 MΩ or more
8 - 7	INFO	ON	Less than 1 Ω

Model with SI-DRIVE

Model without steering heater

Courtesy of SUBARU OF AMERICA, INC.

Terminal No.	Inspection conditions		Standard
(ST3) No. 7 - (ST11) No. 1	INFO	OFF	3 MΩ or more
(ST3) No. 7 - (ST11) No. 1	INFO	ON	Less than 1 Ω

Model with steering heater

Courtesy of SUBARU OF AMERICA, INC.

Terminal No.	Inspection conditions		Standard
(ST3) No. 7 - (ST9) No. 2	INFO	OFF	3 MΩ or more
(ST3) No. 7 - (ST9) No. 2	INFO	ON	Less than 1 Ω

Apply battery voltage between the connector terminals to check lighting condition of illumination inside the switch.

CAUTION:

When applying battery voltage, do not mix up the positive (+) side and the negative (-) side.

Incorrect polarity connection may cause LED damage inside the switch.

Terminal No.	Inspection conditions	Specification
10 (+) - 11 (-)	Apply battery voltage.	Light ON

If it is found to be defective as a result of the inspection, replace the satellite switch.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.