SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2022IMPREZA BASE, 4D SEDAN, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISELECTRICALGAUGESINSTRUMENTATION SYSTEM & DRIVER INFORMATION CENTERCOMBINATION METER SYSTEMOPERATIONVARIANT WORKOPERATION PROCEDURE A
2022 Subaru Impreza Base, 4D Sedan, Automatic CVT Trans

Operation Procedure A

2022 Subaru Impreza Base, 4D Sedan, Automatic CVT TransSECTION Operation Procedure A
CAUTION:
  • Carry-over of the odometer value is possible only once. If failed, odometer carry-over cannot be performed anymore. 
  • When odometer value reading is performed, the odometer displays "------" and continued use of the combination meter assembly is impossible. 
  • When the power supply of the Subaru Select Monitor is turned OFF during work, the odometer value data is cleared and carry-over becomes impossible. Be careful of the state of power supply connection of Subaru Select Monitor. 
  1. Read and store the setting information and odometer value.
    1. Connect the Subaru Select Monitor and then turn the ignition switch to ON.
    2. Select [Reading and Writing of the ECU Configuration Information and Odometer Value] on [Work Support] of Subaru Select Monitor. Ref. to COMMON (DIAG)>WORK SUPPORT .
    3. Save under a new name according to the display screen.
    4. When [Read odometer value? This will lock the odometer on the meter] is displayed, click the [YES] button.
    5. Confirm that [Odometer value was read] is displayed, and then turn the ignition switch to OFF.
  2. Replace the combination meter assembly with a new part. Ref. to INSTRUMENTATION/DRIVER INFO>COMBINATION METER .
    CAUTION:

    Do not perform the following. Otherwise, saved odometer values will be cleared. 

    • Turn the power supply of Subaru Select Monitor to OFF. 
    • Communication between Subaru Select Monitor and interface for Subaru Select Monitor is lost. (USB cable is disconnected) 
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.