Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSSUBARU2022IMPREZA BASE, 4D SEDAN, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLVEHICLE DYNAMICS CONTROL (VDC) SYSTEMVDC OFF SWITCHINSPECTION
2022 Subaru Impreza Base, 4D Sedan, Automatic CVT Trans
VDC OFF Switch: Inspection
2022 Subaru Impreza Base, 4D Sedan, Automatic CVT TransSECTION Inspection
- Measure the resistance between the VDC OFF switch terminals.
Preparation tool:Β
Circuit tester
Terminal No. Inspection conditions Standard 6 - 8 Switch OFF 1 MΞ© or more Switch ON Less than 1 Ξ© - Apply battery voltage between the connector terminals to check lighting condition of illumination inside the switch.CAUTION:
When applying battery voltage, do not mix up the positive (+) side and the negative (-) side.Β
Incorrect polarity connection may cause LED damage inside the switch.Terminal No. Inspection conditions Specification 1 (+) - 4 (-) Apply battery voltage. Light ON - Replace the VDC OFF switch if the inspection result is not within the standard value.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.