Check With SUBARU Select Monitor

2022 Subaru Impreza Base, 4D Sedan, Automatic CVT TransSECTION Check With SUBARU Select Monitor
  1. Using Subaru Select Monitor, select [RR Wheel Speed] and [RL Wheel Speed] from the list of Data Monitor items.
  2. Check if the speed indicated on the display changes in the same manner as the speedometer reading during acceleration/deceleration when the steering wheel is in the straight-ahead position.
  3. If the inspection result shows that the value for either side alone does not change on the display screen, swap the ABS wheel speed sensors between LH and RH and then check again to see if the value changes or not.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.