SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2022IMPREZA BASE, 4D SEDAN, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLVEHICLE DYNAMICS CONTROL (VDC) SYSTEMFRONT ABS WHEEL SPEED SENSORREMOVAL
2022 Subaru Impreza Base, 4D Sedan, Automatic CVT Trans

Front ABS Wheel Speed Sensor: Removal

2022 Subaru Impreza Base, 4D Sedan, Automatic CVT TransSECTION Removal
  1. Disconnect the ground terminal from battery sensor. Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
    NOTE:

    For the hybrid model, disconnect the battery negative terminal. 

  2. Lift up the vehicle, and then remove the front wheels.
  3. Remove the front ABS wheel speed sensor.
    CAUTION:
    • Be careful not to damage the sensor. 
    • Do not apply excessive force to the sensor harness. 
    • Leave the sensor harness clamp on the vehicle side. 
    1. Disconnect the connector of the front ABS wheel speed sensor in the engine compartment.
      G13602593Courtesy of SUBARU OF AMERICA, INC.
    2. Remove each harness clip and grommet.
    3. Remove the front ABS wheel speed sensor from the front axle housing.
G13231474Courtesy of SUBARU OF AMERICA, INC.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.