SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2022IMPREZA BASE, 4D SEDAN, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISBODY & FRAMEWINDOWSWINDOW GLASS & MIRRORSPOWER WINDOW CONTROL SWITCHINSPECTIONSUB-SWITCHSWITCH - POWER WINDOW SUB FRONT
2022 Subaru Impreza Base, 4D Sedan, Automatic CVT Trans

Switch - Power Window Sub Front

2022 Subaru Impreza Base, 4D Sedan, Automatic CVT TransSECTION Switch - Power Window Sub Front
  1. Measure the resistance between terminals of the switch - power window sub front.

    Preparation tool: 

    Circuit tester

    G12398775Courtesy of SUBARU OF AMERICA, INC.
    • Passenger's seat sub
      Terminal No. Inspection conditions Standard
      6 - 5
      6 - 7      		 OFF Less than 1 Ω
      2 - 5
      2 - 6      		 1 MΩ or more
      2 - 6
      5 - 7      		 Manual UP Less than 1 Ω
      2 - 5
      6 - 7      		 1 MΩ or more
      2 - 5
      6 - 7      		 Manual DOWN Less than 1 Ω
      2 - 6
      5 - 7      		 1 MΩ or more
  2. Apply battery voltage between the switch - power window sub front terminals to check lighting condition of illumination inside the switch.
    CAUTION:

    When applying battery voltage, do not mix up the positive (+) side and the negative (-) side. 

    Incorrect polarity connection may cause LED damage inside the switch. 

    Terminal No. Inspection conditions Standard
    7 (+) - 2 (-) Apply battery voltage. Light ON
  3. Replace the switch - power window sub front if it is found defective from the inspection result.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.