Active Test: List

2022 Subaru Impreza Base, 4D Sedan, Automatic CVT TransSECTION List
Active test item Range Contents Execution condition
Power Window Operation Test UP
DOWN
cancel
By forcibly operating the power window motor, it is possible to determine whether motor's up, down, and stop functions work normally.
  • Ignition switch ON
  • Initialized state
  • Pulse fail not detected
  • UP terminal input OFF
  • DN terminal input OFF
  • AUTO terminal input OFF
  • Power window stops
LED Switch Lighting Test (Passenger's side only) Check
cancel
It is possible to determine whether ON and OFF functions of power window passenger's side switch LED work normally. (When Diagnosis mode is switched)
NOTE:

The LED should come on and off as the ignition switch is turned ON and OFF.Β 

Ignition switch ON
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.