SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2022IMPREZA BASE, 4D SEDAN, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINFOTAINMENTENTERTAINMENT SYSTEMAUDIOREMOVAL
2022 Subaru Impreza Base, 4D Sedan, Automatic CVT Trans

Entertainment System: Audio: Removal

2022 Subaru Impreza Base, 4D Sedan, Automatic CVT TransSECTION Removal
  1. Disconnect the ground terminal from battery sensor. Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
    NOTE:

    For the hybrid model, disconnect the battery negative terminal. 

  2. Remove the grille assembly - CTR ventilation. Ref. to AIR CONDITIONER (EXCEPT FOR HEV)>AIR VENT GRILLE>REMOVAL>CENTER GRILLE ASSEMBLY .
  3. Remove the panel - center UPR.
    1. Release the clips and claws, then detach the panel - center UPR.
      G11246744Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the audio assembly.
    1. Remove the screws.
    2. Release the clips and disconnect the connector, and then remove the audio assembly.
      G11246745Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the backup unit. Ref. to SECURITY AND LOCKS>BACKUP UNIT>REMOVAL .
  6. Remove the data communication module. (Model with telematics) Ref. to ENTERTAINMENT & MONITORING>DATA COMMUNICATION MODULE>REMOVAL>DATA COMMUNICATION MODULE .
  7. Remove the audio bracket.
    1. Remove the screws, and then remove the audio bracket.
      G13606386Courtesy of SUBARU OF AMERICA, INC.
      NOTE:

      Remove the screws on LH side in the same procedure as on the RH side. 

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.