Body Control System (Diagnostics): Customize: List

2022 Subaru Impreza Base, 4D Sedan, Automatic CVT TransSECTION List
CAUTION:
  • The setting items must match the actual vehicle equipment.Β 
  • Do not change settings except for setting below while setting the functions.Β 
  • Be sure not to change Factory initial setting except when installing a new body integrated unit.Β 
Item Initial setting value Setting value Contents
Off delay time 30s OFF 10 Sec 20 Sec 30s Room light off delay time can be selected.
Auto Light Sensitivity Adjustment Sensitive Dull Normal Sensitive Very sensitive Sensitivity of the automatic lighting can be adjusted.
Remote Trunk Open/Power Rear Gate Open Function Press and hold OFF Press twice Press and hold Keyless transmitter-operated trunk open/power rear gate open can be selected.
Lane change signal setting Yes ON OFF Yes: One-touch blinker function operates.
No: One-touch blinker function does not operate.
Rear wiper auto setting No (U0, U4, U5 model) Yes: (C0, C5 model) ON OFF Yes: Rear wiper operates intermittently in sync with the reverse shift, when the front wiper is at continuous wiping.
No: Rear wiper does not operate intermittently in sync with the reverse shift, when the front wiper is at continuous wiping.
Driver's Door Unlock Setting Selection Selection ALL Selection: When the touch sensor (unlock) on the driver's side is touched, only the driver's door is unlocked. When the touch sensor (unlock) on the passenger's side is touched, all doors are unlocked.
ALL: When the touch sensor (unlock) on the driver's side is touched, all doors are unlocked. When the touch sensor (unlock) on the passenger's side is touched, all doors are unlocked.
Rear Gate Unlock Setting Selection Selection ALL Selection: When the rear gate opener button is pressed, only the rear gate is unlocked.
ALL: When the rear gate opener button is pressed, all doors are unlocked.
Daytime Running Light(DRL) Setting for North America (1) High beam dimming system Dedicated light system Set according to the daytime running light source type.
Wiper link Auto Light Setup (1) ON OFF ON: Wiper interlock auto light function is activated. OFF: Wiper interlock auto light function is deactivated.
Steering Wheel Left Left Right Left: Left hand drive.
Right: Right hand drive.
Vehicle Automatic Door Lock Vehicle speed OFF Vehicle speed Select lever P OFF: Vehicle automatic door lock is not activated.
Vehicle speed: Vehicle automatic door lock is activated at or above a certain vehicle speed.
Select lever P: Vehicle automatic door lock is activated when the select lever is shifted from P to other than P.
Vehicle Automatic Door Unlock Driver's door open OFF Select lever P Power OFF Driver's door open OFF: Vehicle automatic door unlock is not activated.
Select lever P: Vehicle automatic door unlock is activated when the select lever is shifted from other than P to P. Power OFF: Vehicle automatic door unlock is activated when the IGN is turned from ON to OFF.
Driver's door open: Vehicle automatic door unlock is activated when the driver's door is operated from Close to Open.
Steering Responsive Fog Lamp Setting No Yes No Yes: Activates the SRF function.
No: Deactivates the SRF function. (Except for hybrid model)
Head Lamp Low Beam Specification (1) Halogen HID LED Set according to the headlight type.
Head Lamp High Beam Specification (1) Halogen HID LED Set according to the headlight type.
High Beam Assist Current Setting ON ON OFF Activated when [High Beam Assist Function Setting (mirror/EyeSight)] is set to other than [No].
ON: High beam assist is activated. OFF: High beam assist is not activated.
High Beam Assist Function Setting (mirror/EyeSight) (1) No mirror HBA EyeSight HBA Set to Yes for models with high beam assist.
Vehicle Automatic Door Lock/Unlock and Impact Detection Door Lock Setting Yes Yes No Yes: Vehicle auto door lock control/vehicle auto door unlock control/collision detection door unlock control is present.
No: Vehicle auto door lock control/vehicle auto door unlock control/collision detection door unlock control is absent.
Rear defogger operation mode 15 minutes (normal) Normal Continuous Normal: Automatically stops in 15 minutes after the switch is turned to ON.
Continuous: Repeats the cycle of 15-minute active condition and 2-minute inactive condition until the switch is turned to OFF.
Security Alarm Setup ON ON OFF ON: Warning function (hazard, horn) is activated.
OFF: Warning function (hazard, horn) is deactivated.
Impact Sensor Setup OFF ON OFF ON: Impact sensor is activated.
OFF: Impact sensor is deactivated. (Set to "OFF" in models without the impact sensor.)
Alarm delay setup ON ON OFF ON: The alarm monitor starts 30 seconds after the keyless lock operation.
OFF: The alarm monitor starts immediately after the keyless lock operation.
Lockout prevention ON ON OFF ON: Key lockout prevention function is activated. (The function does not operate if safety knob is locked by hand.)
OFF: Key lockout prevention function is deactivated.
Impact sensor No Yes No Yes: Vehicle is controlled in impact sensor equipped mode. (Make sure to set to "No" for models without the impact sensor. When set to "Yes", hazard, horn or siren become activated by keyless lock (alarm monitor start).) No: Vehicle is controlled in no impact sensor mode.
Buzzer sounding setting ON ON OFF ON: Buzzer sounds when lock/unlock is selected by keyless entry system.
OFF: Buzzer does not sound when lock/unlock is selected by keyless entry system.
Abnormal warning lamp flashing setting ON ON OFF ON: Buzzer sounds when lock/unlock is selected by keyless entry system.
OFF: Buzzer does not sound when lock/unlock is selected by keyless entry system.
Door open warning Yes Yes No Yes: If a door stays half shut for 20 minutes, interior lighting linked with the door such as room light, map light, luggage room light, trunk room light and key ring illumination go off to prevent battery run-out.
No: Room light, map light, luggage room light, trunk room light, key ring illumination and door warning light remain lit.
Dome Light Alarm Setting OFF ON OFF ON: Room light illumination is interlocked with the alarm.
OFF: Room light illumination is not interlocked with the alarm.
Auto A/C Setting (1) Yes No Yes: Equipped with auto A/C control module.
No: Not equipped with auto A/C control module.
Wiper Deicer setting (1) Yes No Yes: With the wiper deicer function.
No: Without the wiper deicer function.
Sedan/Wagon Setting (1) Sedan Wagon Sedan: Sedan model.
Wagon: Wagon model.
MT/AT Setting (1) AT MT AT: AT model.
MT: MT model.
Seat Memory Setting (1) Yes No Yes: Equipped with seat memory.
No: Not equipped with seat memory. (Except for hybrid model)
Illumination Sensor Setting (1) Yes No Yes: Equipped with illumination sensor.
No: Not equipped with illumination sensor.
Factory initial setting Market Factory Market Factory: Factory mode
Market: Market mode
EPB setting (1) Yes No Yes: Equipped with EPB.
No: Not equipped with EPB.
Sunroof setting (1) Yes No Yes: Equipped with sunroof control module.
No: Not equipped with sunroof control module. (For models other than for North America, the setting is fixed to "No" for vehicles even equipped with sunroof.) (Except for hybrid model)
Welcome Light Off Delay Time(Exiting) 30 seconds OFF
30 seconds
60 seconds
90 seconds
Lighting time length of the welcome lighting (exit) function can be set.
Welcome Light Off Delay Time(Approaching) 30 seconds OFF
30 seconds
60 seconds
90 seconds
Lighting time length of the welcome lighting (approaching) function can be set.
Keyless Buzzer Volume 5 1 - 7 Buzzer volume can be set.
Auto Dimmer Cancel Setting 3 0 (OFF) Least Less Normal More Most Auto dimmer cancel sensitivity can be set.
Trunk Request SW Setup ON ON
OFF
ON: The trunk opener switch-operated trunk open function is activated.
OFF: The trunk opener switch-operated trunk open function is deactivated. (Models without the keyless access with push button start system)
(1) Customization item according to the actual vehicle equipment
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.