SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2022IMPREZA BASE, 4D SEDAN, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEDOOR LOCKSANTI-THEFT SYSTEM - SECURITY AND LOCKSREMOTE OPENERSREMOVALTRUNK LID OPENER
2022 Subaru Impreza Base, 4D Sedan, Automatic CVT Trans

Trunk Lid Opener

2022 Subaru Impreza Base, 4D Sedan, Automatic CVT TransSECTION Trunk Lid Opener
  1. Remove the cover - handle.
    1. Release the claws, and open the cover.
    2. Remove the screws and release the claws, then detach the cover - handle.
      G11246332Courtesy of SUBARU OF AMERICA, INC.
  2. Remove the pull handle - opener.
    1. Remove the nut.
    2. Remove the cable assembly - trunk lid and the cable assembly - fuel from the pull handle - opener.
      G11246333Courtesy of SUBARU OF AMERICA, INC.
  3. Remove the trim panel - trunk mat and the spacer - CTR.
  4. Remove the spacer - rear floor front.
    1. Release the clips, and fold back the bottom of the cover COMPL - rear backrest LH and RH of the rear seat back.
      G11246334Courtesy of SUBARU OF AMERICA, INC.
    2. Release the clips, then detach the spacer - rear floor front.
      G11246335Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the trim panel - trunk side RH and trim panel - trunk lid. Ref. to EXTERIOR/INTERIOR TRIM>TRUNK ROOM TRIM>REMOVAL .
  6. Remove the lower inner trim. Ref. to EXTERIOR/INTERIOR TRIM>LOWER INNER TRIM>REMOVAL .
  7. Remove the cable assembly - trunk lid.
    1. Release the claws, and open the cover of the lock assembly - trunk lid.
    2. Remove the cable assembly - trunk lid from the lock assembly - trunk lid.
      G11246319Courtesy of SUBARU OF AMERICA, INC.
    3. Remove the cable clip, and remove the cable assembly - trunk lid.
      G13235083Courtesy of SUBARU OF AMERICA, INC.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.