Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2022IMPREZA BASE, 4D SEDAN, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTINTERIOR/ILLUMINATION LIGHTSLIGHTING SYSTEMSIDE TURN SIGNAL LIGHT ASSEMBLYINSPECTION
2022 Subaru Impreza Base, 4D Sedan, Automatic CVT Trans
Side Turn Signal Light Assembly: Inspection
2022 Subaru Impreza Base, 4D Sedan, Automatic CVT TransSECTION Inspection
- Apply battery voltage between the connector terminals to check the lighting condition of the light.
Terminal No. Inspection conditions Specification 1 (+) - 2 (-) Apply battery voltage. Light ON - Replace the light assembly - side turn mirror if faulty is found in the inspection.NOTE:
Since LED (Light Emitting Diode) is used for the light, replace the light assembly - side turn mirror if the light does not illuminate.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.