Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Subaru Crosstrek Base, Automatic CVT TransFACTORY OEM SERVICE PROCEDURE
Inspection Mode A
| DTC | Item |
|---|---|
| P1F00 | SELF-SHUT OFF RELAY CIRCUIT LOW |
| P1F05 | SYSTEM VOLTAGE |
| P1F06 | INTERNAL CONTROL MODULE KEEP ALIVE MEMORY (KAM) ERROR |
| P1F07 | INTERNAL CONTROL MODULE RANDOM ACCESS MEMORY (RAM) ERROR |
| P1F08 | INTERNAL CONTROL MODULE READ ONLY MEMORY (ROM) ERROR |
| P1F09 | CONTROL MODULE PROCESSOR |
| P1F0A | INTERNAL CONTROL MODULE EEPROM ERROR |
| P1F0B | AWD POWER SUPPLY VOLTAGE |
| U0073 | CONTROL MODULE COMMUNICATION BUS OFF |
| U0122 | LOST COMMUNICATION WITH VEHICLE DYNAMICS CONTROL MODULE |
| U0129 | LOST COMMUNICATION WITH BRAKE SYSTEM CONTROL MODULE |
| U0293 | LOST COMMUNICATION WITH HYBRID POWERTRAIN CONTROL MODULE |
| U0416 | INVALID DATA RECEIVED FROM VEHICLE DYNAMICS CONTROL MODULE |
| U0418 | INVALID DATA RECEIVED FROM BRAKE SYSTEM CONTROL MODULE |
| U0594 | INVALID DATA RECEIVED FROM HYBRID POWERTRAIN CONTROL MODULE |
Diagnostic procedure:
- Turn the ignition switch to ON.
- Wait for 10 sec or more.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
