2021 Subaru Ascent BaseFACTORY OEM SERVICE PROCEDURE

When The CROSSMEMBER COMPL Front Was Not Removed

  1. Use a new O-ring to install the oil level switch, and secure the harness with the clip.
    NOTE: Apply engine oil to O-ring.

    Tightening torque:Β 

    6.4 N.m (0.7 kgf-m, 4.7 ft-lb)

    G13199185Courtesy of SUBARU OF AMERICA, INC.
  2. Secure the harness with clip, and connect the connector.
    G13199164Courtesy of SUBARU OF AMERICA, INC.
  3. Install the engine mounting LH.

    Tightening torque:Β 

    35 N.m (3.6 kgf-m, 25.8 ft-lb)

  4. Lower the engine and remove the lifting device and wire ropes.
  5. Remove the ST.
  6. Install the pitching stopper. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR690)>Transmission Mounting System>INSTALLATION>PITCHING STOPPER .
  7. Install the front drive shaft LH. Ref. to PROPELLER SHAFT/DRIVE SHAFT/AXLE>Front Drive Shaft>INSTALLATION .
  8. Install the electric power steering gearbox. Ref. to POWER ASSISTED SYSTEM (POWER STEERING)>Electric Power Steering Gearbox>INSTALLATION .
  9. Install the nuts which hold the engine mounting to the crossmember COMPL front.
    CAUTION: Be sure to use a new nut.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.