2021 Subaru Ascent BaseFACTORY OEM SERVICE PROCEDURE

Pitching Stopper

  1. Remove the intercooler. Ref. to INTAKE (INDUCTION) (H4DOTC)>Intercooler>REMOVAL .
  2. Disconnect the air breather hose from the clip.
    G13200011Courtesy of SUBARU OF AMERICA, INC.
  3. Disconnect the ground cord.
    1. Remove the clip.
    2. Disconnect the coupling connector.
    G13200012Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the pitching stopper plate.
    G13200013Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the pitching stopper.
    G13200014Courtesy of SUBARU OF AMERICA, INC.
  6. Remove the pitching stopper bracket.
    NOTE: Perform this procedure only when required.
    G13621925Courtesy of SUBARU OF AMERICA, INC.
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.