2019 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE

Select Lever: Installation

WARNING: This page is about a different car, the 2022 Subaru WRX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the select cable to the select lever. Ref. to CONTROL SYSTEMS>SELECT CABLE>INSTALLATION .
  2. Install the select lever.

    Tightening torque: 

    18 N.m (1.8 kgf-m, 13.3 ft-lb)

  3. Install the clip securing the harness.
  4. Connect the connector.
    G14602396Courtesy of SUBARU OF AMERICA, INC.
  5. Connect the select cable to the transmission main body. Ref. to CONTROL SYSTEMS>SELECT CABLE>INSTALLATION .
  6. Install the cover center side. Ref. to EXTERIOR/INTERIOR TRIM>CENTER CONSOLE>INSTALLATION .
  7. Install the clamp to the grip.
    NOTE:

    Insert it from the front side. 

  8. Install the grip.
    NOTE:

    Install it while pressing on the clamp. 

  9. Install the boot to the grip.
  10. Release the shift lock using a screwdriver, etc. and shift the select lever to the "P range".
  11. Install the mat center tray.
  12. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.