2019 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE

Select Cable: Installation

WARNING: This page is about a different car, the 2022 Subaru WRX. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Check that the protector (b) is set between the clamps (a). 
  • If the protector (b) is offset, set it between the clamps (a). 
G13935596Courtesy of SUBARU OF AMERICA, INC.
  1. Install the cable bracket.
    CAUTION:

    Be careful not to twist the boot. 

    Tightening torque: 

    18 N.m (1.8 kgf-m, 13.3 ft-lb)

    G14602406Courtesy of SUBARU OF AMERICA, INC.
  2. Set a new clamp on the select lever and secure it by bending the claw.
    NOTE:

    Install it with the claw facing the rear side. 

  3. Insert the select cable into the select lever and secure it with the clamp.
    CAUTION:

    Do not apply excessive load while holding the part (a). 

    G14602404Courtesy of SUBARU OF AMERICA, INC.
    G14602410Courtesy of SUBARU OF AMERICA, INC.
  4. Temporarily Install the adjusting nut (rear) to the select cable.
  5. Apply grease to the shifter arm.

    Preparation items: 

    Grease: NIPPON GREASE NIGTIGHT LTS No. 2 or equivalent

    G14602411Courtesy of SUBARU OF AMERICA, INC.
  6. Connect the select cable to the transmission main body.
    CAUTION:

    Do not apply excessive load while holding the part (a). 

    G14602401Courtesy of SUBARU OF AMERICA, INC.
    NOTE:

    Set the washer before installing the snap pin. 

    Tightening torque: 

    25 N.m (2.5 kgf-m, 18.4 ft-lb)

    G14602402Courtesy of SUBARU OF AMERICA, INC.
  7. Adjust the select cable free play. Ref. to CONTROL SYSTEMS>SELECT CABLE> ADJUSTMENT .
  8. Install the center exhaust cover and rear exhaust pipe. Ref. to EXHAUST (H4DOTC)>REAR EXHAUST PIPE>INSTALLATION .
  9. Install the center exhaust pipe (rear). Ref. to EXHAUST (H4DOTC)>CENTER EXHAUST PIPE>INSTALLATION>CENTER EXHAUST PIPE (REAR) .
  10. Release the shift lock and shift the select lever to the "P range". Ref. to CONTROL SYSTEMS>SELECT LEVER>INSTALLATION .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.